When we use gasoline generators on a daily basis, we sometimes encounter partial leakage of the generator. This type of leakage is mostly caused by wear and corrosion of generators . In the face of this slight oil leakage problem, we What should be done? Today Xiaobian made some simple summaries on the solution to the problem of oil leakage in the common parts of gasoline generators and shared them here.
Â
Â
First, glue repair glue leakage method
Because oil tanks, water tanks, oil pipes, and water pipes cause small-scale oil leaks due to blisters, pores, etc., use a sticky adhesive to smear the cleaned crushing place.
Second, the size of the plastic recovery method
When the gasoline engine shaft and bushings, bearings and housings, valves and valves, self-tightening oil seals, fillers, etc., when the oil can be used size recovery adhesive smear in the clean common parts wear parts, after curing to form a wear-resistant, mechanical Stronger film layer.
Padded control leakage method
Gasoline generator leaks at the leak-proof washers of the oil pipe joints. A double-sided, smooth and thin plastic pad can be added on both sides of the leak-proof washers. Tighten tightly to prevent leakage.
Third, anaerobic glue leakage method
When the vent bolts, stud bolts, etc. on the generator are leaking, they can be coated with anaerobic adhesive on the threads or screw holes of the cleaned bolts. It can be quickly cured to form a thin film and fill the gaps of parts; this method is better for leak control of high pressure oil pipe joints in gasoline engines.
Fourth, to drain the law
When the gasoline generator bottom case, cylinder head, gear chamber cover, crankcase back cover and other paper pads leak, if the paper pad is not damaged and the joint surface is clean, you can apply a layer on both sides of the paper pad butter. Tighten the bolts again to prevent leaks. If you want to change the paper pad, you need to soak the new paper pad in gasoline for 10 minutes, then remove it, and wipe it with a layer of butter on the joint surface.
Aluminum Alloy Conductor Stringing Come Along Clamps
Insulated conductors for tighttening or adjustment of sag with.
Forging of high strength aluminum titanium alloy used,light weight.
The jaw part by special reticulate processing,both in summer and winter can firmly clamp the cable and does not hurt the inner core.
There are many types of Come Along Clamp :
Come Along Clamp,Come Along Tool,Come Along Clamp For Cable,Optical Cable Come Along Clamp
Hebei Long Zhuo Trade Co., Ltd. , https://www.hblongzhuo.com