With the improvement of technology, thermal shock chambers of the technology also has a very good improvement, but even the best equipment, you will not care, but how long do? This problem is very clear to everyone. Therefore, learning the relative maintenance measures , the benefits to the equipment, and the benefits to us are also numerous. Teddy chapter tells the story of your company for maintenance of hot and cold impact test chamber:
  2, condenser dust removal of high and low temperature impact tester The condenser is best to maintain regularly on a monthly basis, and to use high-pressure air to spray dust or use a vacuum cleaner to remove the dust attached to the condenser cooling network clean;
4. When the test cloth surface of the device is not clean or hardened, the wet ball test cloth of the device needs to be replaced. Or after the temperature control is finished, if you want to continue to do temperature and humidity sphericity control, you must replace the test cloth before use. (The test cloth is replaced every three months. After the replacement, the temperature measuring body is wiped with a clean cloth. The new test cloth should be cleaned first)
3. Check the wet bulb water level of the equipment and adjust the water level of the water accumulation drum. The water level of the water accumulation drum may not be too high. Otherwise, the water will overflow the water collection drum or the water level is too low to make the wet bulb test cloth absorb water abnormally. Should keep six minutes full. (To adjust the water level of the water trap, adjust the height of the water trap.)
1. Humidifier inspection and maintenance of the high-low temperature impact test box The best way to store the water in the humidifier is to change it every month, and ensure that the cleanliness of the water is up to the target and the water is smooth;
    Â
   A good device needs a good maintenance measure. Therefore, when using the high-low temperature impact test box, the operator must maintain it well so that its service life can be extended and the performance can be more stable.
Transition idlers are found at either end of the conveyor, adjacent to the head and tail pulleys. These idler sets comprise standard idler rolls however the bases into which these rolls are fitted, have a smaller troughing angle to that of the rest of the troughing / carry idlers on the conveyor. Transition Idler Assemblies are available in 3 or 5 roll configurations to suit required belt width, trough angle and roller spacing.
The reason for this is that the conveyor belt is flat as it passes over the pulleys, under high tension. As the belt changes its form to a full trough of say, 35 degrees (i.e. from tail pulley to full trough angle), the belt must be supported through this transition zone. If the belt was fed directly into a full trough from the tail pulley, the belt edges would be over-stressed and damage would result. Similarly, as the troughed angle changes to zero at the head- end, transition idlers provide support through the transition zone. The number of transition idlers required depends on the trough angle of the conveyor.
The number of transition idlers depends on the trough angle of the conveyor. In the case of a 45 degree trough angle, 2 or 3 Transition Idler Sets would be used at either end of the conveyor. As with troughing idlers, transition idlers are available in fixed bases or the garland configuration.
the combination of different XKTE rolling bearings makes it possible to respond to heavy load. Big clearance deep groove ball bearings are utilized in open pit and underground mining.
To be the first class, to do the best quality, to make users satisfied, to ensure customers relieved, are our enterprise purposes. Welcome bearing dealers` and Conveyor Idler manufacturers contact from all over the world, and become our partner.
Transition Idler
Transition Idler,Transition Idler Sets,Cheap Transition Idler
Shandong Xinkaite Bearing Co., Ltd. , https://www.idlerbearing.nl